Страница: 5 из 152
i.
ON
j.
ADDRESS
3.
Press the up arrow or the down arrow to select the first character of the address. Press the
OK
button.
Repeat this process for each character in the address.
NOTE:
You must press the
OK
button after entering each character.
4.
Press the up arrow or the down arrow to select the stop character . Press the
OK
button.
5.
Press the
Home
button to return to the Ready state.
Manually configure IPv4 TCP/IP parameters from the control panel
1.
Press the
Home
button .
2.
Open each of the following menus. Press the down arrow to highlight it and then press the
OK
button to select it.
a.
CONFIGURE DEVICE
b.
I/O
c.
EMBEDDED JETDIRECT MENU
d.
TCP/IP
e.
IPV4 SETTINGS
f.
CONFIG METHOD
g.
MANUAL
h.
MANUAL SETTINGS
i.
<IP ADDRESS>, SUBNET MASK, or DEFAULT GATEWAY
3.
Press the up arrow or the down arrow to increase or decrease the number for the first byte
of the IP address, subnet mask, or default gateway.
4.
Press the
OK
button to move to the next set of numbers, or press the back arrow to move to
the previous set of numbers.
5.
Repeat steps 3 and 4 until the IP address, subnet mask, or default gateway is complete, and
then press the
OK
button to save the setting.
6.
Press the
Home
button to return to the Ready state.
ENWW
Network installation
3
EN
3
HP LaserJet Information Engineering