New Zealand Telecom Warning Notice Laserjet printer HP Серия мультифункциональных принтеров HP LaserJet 9040 и 9050

Page: 141 from 148

background image

Other regulatory information

Regulatory information for EU countries/regions

This equipment has been designed to work in all countries/regions of the European Economic Area
(Public Switched Telephone Networks). Network compatibility is dependent on internal software
settings. Contact your equipment supplier if it is necessary to use the equipment on a different telephone
network. For further product support, contact Hewlett-Packard at the phone numbers provided in the
support flyer that came with the product.

New Zealand Telecom Warning Notice

1.

The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It indicates
no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it
provides no assurance that any item will work correctly in all respects with another item of
Telepermitted equipment of a different make or model, nor does it imply that any product is
compatible with all of Telecom's network services.

This equipment is not capable under all operating conditions of correct operation at the higher
speed which it is designated. 33.6 kbps and 56 kbps connections are likely to be restricted to lower
bit rates when connected to some PSTN implementations. Telecom will accept no responsibility
should difficulties arise in such circumstances.

2.

Immediately disconnect this equipment should it become physically damaged, and arrange for its
disposal or repair.

3.

This modem shall not be used in any manner, which could constitute a nuisance to other Telecom
customers.

4.

This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There
is no guarantee that Telecom lines will always continue to support pulse dialing.

Use of pulse dialing, when this equipment is connected to the same line as other equipment, may
give rise to 'bell tinkle' or noise and may also cause a false answer condition. Should such problems
occur, the user should not contact the Telecom Faults Service.

The preferred method of dialing is to use DTMF tones, as this is faster than pulse (decadic) dialing
and is readily available on almost all New Zealand telephone exchanges.

5.

Warning Notice: No '111' or other calls can be made from this device during a mains power failure.

6.

This equipment may not provide for the effective hand-over of a call to another device connected
to the same line.

7.

Some parameters required for compliance with Telecom's Telepermit requirements are dependent
on the equipment (PC) associated with this device. The associated equipment shall be set to
operate within the following limits for compliance with Telecom's Specifications:

For repeat calls to the same number:

There shall be no more than 10 call attempts to the same number within any 30-minute period
for any single manual call initiation, and

The equipment shall go on-hook for a period of not less than 30 seconds between the end of
one attempt and the beginning of the next attempt.

ENWW

Other regulatory information 133