IDE connector (- pin PRIIDE) Asus prime Asus M3A78-EH

Page: 42 from 98

background image

1-30

Chapter 1: Product introduction

3.  IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for an Ultra DMA 133/100/66 signal cable. 

There are three connectors on each Ultra DMA 133/100/66 signal cable: 

blue, black, and gray. Connect the blue connector to the motherboard’s IDE 

connector, then select one of the following modes to configure your device(s).

•  Pin 20 on the IDE connector is removed to match the covered hole on the 

Ultra DMA cable connector. This prevents incorrect insertion when you 

connect the IDE cable.

•  Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select,” make sure all other device 

jumpers have the same setting.

Drive jumper setting

Mode of 

device(s)

Cable connector

Single device

Cable-Select or Master

-

Black

Two devices

Cable-Select

Master

Black

Slave

Gray

Master

Master

Black or gray

Slave

Slave

R

M3A78-EH

M3A78-EH IDE Connector

NOTE: Orient the red markings

(usually zigzag) on the ID

ribbon cable to PIN 1.

PRI_IDE

PIN1