1.10.2 Internal connectors Asus prime Asus M3A78

Page: 30 from 58

background image

2. 

IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for an Ultra DMA 133/100/66 signal cable. There are 

three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. 

Connect the blue connector to the motherboard’s IDE connector, then select one of the 

following modes to configure your device(s).

•  Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA 

cable connector. This prevents incorrect insertion when you connect the IDE cable.

•  Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select,” make sure all other device jumpers have the 

same setting.

Drive jumper setting

Mode of device(s)

Cable connector

Single device

Cable-Select or Master

-

Black

Two devices

Cable-Select

Master

Black

Slave

Gray

Master

Master

Black or gray

Slave

Slave

M3A78 IDE Connector

R

M3A78

NOTE: Orient the red markings

(usually zigzag) on the ID

ribbon cable to PIN 1.

PRI_IDE

PIN1

1-20

ASUS M3A78