Setting H series Acer H6510BD Plus

Page: 42 from 68

background image

32

En

gl

ish

Internal 5V

Default is "Off". Switch On to supply 5V power for both of power 

on mode and standby mode.

<Note>

1. Before doing OSD Reset: projector detects and shows that inner 

HDMI 2/MHL port after being plugged by non-MHL dongle (ex: 

Chromecast).

2. After doing OSD Reset: If inner HDMI dongle existd and Internal 

5V (OSD) is On simultaneously, Internal 5V (OSD) will be set as On 

and DC 5V Out (OSD) will be set as Off automatically after doing 

OSD Reset. (Since inner HDMI dongle isn't given power by projector 

causing inner dongle's signal is lost and cannot be detected by 

projector)

VGA OUT (Standby)  Default is "Off". Choose "On" to enable VGA OUT connection.
HDMI CEC

Default is "Off". Select “On” to enable HDMI CEC function.

Reset

Press the "ENTER" button and choose "Yes" to return the 

parameters on all menus to the factory default settings.

Security

Security

This projector provides a useful security function for the 

administrator to manage usage of the projector .

Press "ENTER" to change the "Security" setting. If the security 

function is enabled, your must enter the "Administrator Password" 

first before changing the security settings.

Select "On" to enable the security function. The user has to 
enter a password to operate the projector. Please refer to the 

"User Password" section for details.

If "Off" is selected, then the user can turn on the projector 
without password.

Timeout(Min.)
Once "Security" is activated to "On", the administrator can set 

timeout function.

Press 

 or 

 to select the timeout interval.

The range is from 10 minute to 990 minutes.

When the time is up, the projector will prompt the user to 

enter the password again.

The factory default setting of "Timeout(Min.)" is "Off".

Once the security function is enabled, the projector will 

request user to enter password when switch on the projector . 

Both "User Password" and "Administrator Password" can be 

accepted for this dialogue.

User Password

Press "ENTER" to setup or change the "User Password".

Press number keys to set your password on the remote control 

and press "ENTER" to confirm. 

Press 

 to delete character.

Enter the password when you see "Confirm Password" 

displayed.

The password should be between 4 and 8 characters long.

If you select "Request password only when plugging the 

power cord in.", the projector will prompt the user to enter 

the password every time the power cord is plugged.

If you select "Always request password while projector turns 

on.", the user has to enter the password every time when the 

projector is turned on.